MICKE Desk, 105x50 cm

MVR 3,250.00 MRf MVR 2,890.00 MRf
Tax included.

Product Details

It’s easy to keep sockets and cables out of sight but close at hand with the cable outlet at the back.

You can mount the storage unit to the right or left, according to your space or preference.

Air ventilates effectively around your computer or other equipment because of an opening in the back panel.

Drawer stops prevent the drawers from being pulled out too far.

Can be placed in the middle of a room because the back is finished.

You can extend your work surface by combining desks and drawer units. All desks and drawer units in the MICKE series are the same height.

You can adjust the shelves to fit different things, and adjust them again whenever you need to. Adjustable shelves help you use your space more efficiently.

Safety & Compliance

When completed with an add-on unit, the whole combination must be placed against a wall to avoid the risk of tipping.

This product has been developed and tested for domestic use.

Measurements

Width: 105 cm
Depth: 50 cm
Height: 75 cm
Max. load: 50 kg

Materials

Table top/ Side panel/ Bottom panel:
Particleboard, Particle- and fibreboard with honeycomb paper filling (100% recycled paper), Fibreboard, Acrylic paint, Plastic edging, Plastic edging

Supporting leg:
Particle- and fibreboard with honeycomb paper filling (100% recycled paper), Fibreboard, Acrylic paint, Plastic edging, Plastic edging

Cable management/ Back rail/ Shelf/ Front:
Particleboard, Paper foil, Plastic edging, Plastic edging

Drawer side/ Drawer back:
Paper foil

Drawer bottom:
Fibreboard, Acrylic paint
Leg:
Steel, Epoxy/polyester powder coating

Good to Know

May be completed with MICKE add-on unit high.

Be sure to follow the instructions in the manual for charging electronic equipment. We recommend that you switch off the power supply when leaving electronic equipment unattended for a longer period.

Care Guide

Wipe clean with a cloth dampened in a mild cleaner.

Wipe dry with a clean cloth.

For increased stability, re-tighten the screws about two weeks after assembly and when necessary.